![]() ![]() Continuing from procedure 'E' above, set device switch to 'Manual'. Verified with tester that output socket has no power. This simulates that lower tank has water and upper tank is now full. Now added another small piece of wire into the sensor socket and other end into B1 socket. G1 led lit up and motor-on LEDlight stayed on. Continuing from procedure 'D' above, reconnected sensor wire with 'G1' socket. Verified with tester that output socket has power supply. The 'G1' led switched off (indicating no water in the upper tank) and at the same time, the green 'motor on' led light lit up indicating motor has switched on. This is as if the upper tank has become empty. With the power supply still on, disconnected the connection between the sensor and 'G1' socket. Verified with tester that there is no output to the motor. This simulates that lower tank has water and upper tank has water. Switched off power supply, reconnected sensor wire with 'G' socket, and added another small piece of wire into the sensor socket and other end into G1 socket. Verified with tester that there is no power output. The 'G' led switched off (indicating no water in the ground tank) and at the same time, the green 'motor on' led light also switched off. This is as if the lower tank has become empty. With the power supply still on, disconnected the connection between the sensor and 'G' socket. I verified that power is being supplied to the output using the tester. The device worked properly as the 'G' LED come on (indicating there is water in the ground tank) and the 'motor on ' LED come on. This is as if the top tank is empty and bottom tank has water. Electricity cable/wire with plug for 220v power supply to this deviceProcedure:Connect the 220v supply to the device (take care of polarity - 'P' is positive).Set device switch to 'Auto'.A: Inserted one of the small wires into the Sensor socket and the other end of it into the G socket. Small (roughly 6-inch) pieces of wire (3 nos)3. A electricity tester (screw-driver type)2. Here's how I tested the device prior to installation-For this I used:1. Auto Controller for water tank - Works Well ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |